Installation Guide
Table Of Contents
- 1 Safety and warnings
- 2 Components
- 3 Tools
- 4 Appliance and cavity dimensions
- 5 Cabinetry options
- 6 Door panel dimensions
- 7 Custom door panel installation dimensions — RS32A72
- 7 Custom door panel installation dimensions — RS36A72
- 8 Custom door panel installation template (RS32A72)
- 8 Custom door panel installation template (RS36A72)
- 9 Door clearance
- 10 Electrical and plumbing
- 11 Before installation
- 12 Cavity preparation
- 13 Water supply connection
- 14 Power supply connection
- 15 Installation preparation
- 16 Top trim installation
- 17 Positioning into cabinetry
- 18 Aligning inside cabinetry
- 19 Door panel installation — stainless steel
- 20 Door panel installation — custom
- 21 Fixing to cabinetry
- 22 Water filter installation
- 23 Toe kick installation
- 24 Covers and trims installation
- 25 Cabinet trims installation — [A] flexible spring clip method
- 26 Cabinet trims installation — [B] fixed screw method
- 27 Final checklist
- 1 Consignes de sécurité et mises en garde
- 2 Pièces
- 3 Outils
- 4 Dimensions de l’appareil et de la cavité
- 5 Options d’armoires
- 6 Dimensions de panneau de porte
- 7 Dimensions d’installation de panneau de porte sur mesure — RS32A72
- 7 dimensions d’installation de panneau de porte sur mesure — RS36A72
- 8 GABARIT D’INSTALLATION DE PANNEAU DE PORTE sur mesure — RS32A72
- 8 GABARIT D’INSTALLATION DE PANNEAU DE PORTE sur mesure — RS36A72
- 9 DÉGAGEMENT DE LA porte
- 10 Raccordement électrique et plomberie
- 11 Avant l’installation
- 12 Préparation de la cavité
- 13 Connexion d'alimentation en eau
- 14 Connexion d'alimentatioN
- 15 préparation de l'installation
- 16 installation de la garniture supérieure
- 17 positionnement dans les armoires
- 18 alignement dans les armoires
- 19 installation de panneau de porte — En acier inoxydable
- 20 Installation de panneau de porte — sur mesure
- 21 Fixation aux armoires
- 22 Installation du filtre à eau
- 23 Installation de la plinthe
- 24 INSTALLATION DES GARNITURES DE PORTE ET TIROIR
- 25 Installation des garnitures de bâti — [A] méthode avec clip de fixation flexible
- 26 Installation des garnitures de bâti — [B] méthode avec vis fixée
- 27 Liste de vérification finale
34
Attach the door panels
1
Open the door and loosen the M5x10 cross-head screws
(do not remove) at the sides of the doors (A).
2
Hang the door panel by inserting the M8 studs
through the holes of the hanging bracket (B).
3
Slide the forks of the side brackets onto the
screws of the door (C).
4
Screw the M8 washer and nut to each stud (D),
and re-tighten the side screws (E) to fix the
door panel (do not fully tighten). This will
allow opening the door without affecting
adjustment of the door panel.
B
D
C
A
E
Tools
Hex key
FPA spanner
(1)
Cross-head screwdriver
Powered driver (optional)
@0 DOOR PANEL INSTALLATION — CUSTOM