VIl. Precautions Warming In order to prevent fire and electric shock, It Is forbidden to Install and use the electric switch which 1s not equipped with this selling fan. Maintenance and repair of ceiling fans 1. It Is recommended to check the connecting parts of the fan ar least once a year, such as the hanger, the hanging pipe fastening screw and the fan blade,to 3 3 insurance that their connection is still safe and reliable. ’ Installation Instruction 2.
I. Basic parameters 1. Voltage: 110V-230V (60HZ-50HZ) 2. Power: Motor power: 42W; LED power: 36W 3. Wind speed + Color change: 6 wind speed+3 color temperatures (from daylight to warm light} 4. Number of rotating leaves: 5 blades 5. Color: Black/White 6. Fan blade material: ABS 7. Motor material: Pure copper wire winding and high-quality silicon steel starlight efficiency, super wist, energy saving, durable. 8. Control method: Remote control 9. Diameter: 46/56 Inch 10.Length of down rod: 5 inches (12.
b. Please do not fix the bracket directly on the wooden ceiling to prevent the wood screws from loosening and causing danger. ©. After the bracket [s fixed, It must be determined to be able to bear the weight of more than 60 kg (test pull by hand) for safety. d. Ceiling fans cannot be installed on gypsum ceilings. C. The distance between the blades and the selling plane should not be less than 22cm (less than 22cm, the fan will have no wind) RNR Cement calling Cling Plans 3. Select the Down rod A.
6. Install lamp . 9. Wiring A. As shown in Figure 12 below, remove the 3 fording screws of the disc on the motor, % The all-pale disconnect circle breaker with a contact distance of 3mm must be and lock the lamp panel hole corresponding to the disc hole with screws connected to the fixed wiring. B. As shown In Figure 13 below, connect the LED drive Input wire to the lead of the Controller wiring Diagram motor lamp firmly, and Insert the drive output wire tightly Into the light source board, C.
10.Canopy Installation After unpleasing loosen the two screws per-installed on the mounting bracket to match the two holes on the canopy ® V.Balance adjustment method of ceiling fan. >r If there 1s any shaking after ceiling fan Installation, please confirm whether the screws that fix the drop ball, mounting bracket, hanger, leaf shelf, and blade are locked. If one of the above parts is not locked, please re-lock locked, please adjust It as follows. . Change the position of the fan blades: a.