Installation And Assembly

Finished Wall Covering
Water-Resistant
Wall Material
Silicone Sealant
Tile Flange
2x4 Studding
Framing or
Ledger Strip
Bath Rim
Pressure
Sensitive
Tape
Bath
Rim
Pressure
Sensitive
Tape
Tile
Flange
INSTALLATION
Thoroughly Clean the bath rim. Temporarily position the Vinyl bead
around the bath rim as illustrated. Trim excess tape material from
the bath corner areas to form a miter joint. Do not cut totally
through the bead when mitering the corners. Some tiling beads
may require trimming of the bottom edge for proper t.
Apply the length of pressure-sensitive tape to the bath rim 3/4”
(1.9crn) in from the rim edge. Use the bottom edge of the rim as
a guide. Do not remove the paper backing at this time. Cut away
any excess pressure-sensitive tape from the corners to form a miter
joint. Remove the paper backing.
Start the Tile Flange 3/4” (1.9crn) in from the end of the rim.
Position the Tile Flange properly on the bath, as illustrated. Press
the Tile Flange firmly against the pressure—sensitive tape. Repeat
the procedure while working toward the opposite end of the bath.
When the Tile Flange is in place, firmly press the Tile Flange in
place with the heel of your hand to ensure proper adhesion.
The bath is now ready for installation, leveling, framing, and the
application of wall materials. Apply a continuous bead of
high—quality silicone sealant between the bath rim and the edge
of the finished wall. The silicone sealant rnust completely cover the
Vinyl bead to ensure a watertight seal. Wipe away any excess
sealant, and fill any voids.
F O R A LIFE O F S T YLE
TM
206 wembly Road.
New Windsor, NY 12553
Phone: [phone]
Fax: [phone]
info@nextures.com
www.nextures.com
READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT
Risk of improper installation.
Do not apply the Tile Flange or pressure-sensitive tape
in temperatures below 40° F (4° C) .
TILE FLANGE
INSTALLATION INSTRUCTION
BEFORE YOU BEGIN
This Tile Flange is intended to fill the gap between the bath rim and the finished wall material on apronless bath installations.
You must apply a continuous bead of high quality silicone sealant, as illustrated, to obtain a watertight seal.
There is enough Tile Flennge supplied for any Fine Fixtures apronless bath. Some cutting will be required. The installation kit
contains a Tile Flange and a length of pressure-sensitive tape.
Apply the Tile Flange to the bath rim before installing the bath.