Instructions

FERM B.V. • Lingenstraat 6 • 8028 PM Zwolle, The Netherlands • P.O. Box 30159 • 8003 CD Zwolle, The Netherlands
Phone: [phone] • Fax: [phone] • www.ferm.com
ERRATUM – SSM1007 MANUAL
Erratum to manual of SSM1007 dated 01-02-2018. Regarding chapter ‘4. Operation’ section ‘Switching on/off’. The
description in this section should be as follows:
Switching on/off
Fig. A1
Place the machine onto a flat and solid surface. Place the Foot pedal switch (10) on the ground.
The machine can be switched on/off when the pedal is actuated. A foot pedal switch for switching on/off is practical,
especially for internal cuttings, since your hands are kept free and you can fully concentrate on the work piece under
the scroll saw. The foot pedal switch cannot influence the speed (see below Speed Adjustment).
Beware of unintentional actuation of the foot pedal sw itch.
Caution! Always choose the preferred operation mode with the Operation switch (13) before using the
machine. The machine will not start in ‘O’ mode.
Continuous operating mode
• Use the Operation switch (13) to choose for ‘I’ continuous operation.
• Connect the scroll saw to the mains.
• Start the machine by pushing the green ON-switch (1).
Push the red OFF-switch (1) to turn the machine off.
Foot pedal operating mode
• Use the Operation switch (13) to choose for ‘II’ foot pedal operation.
• Connect the scroll saw to the mains.
• Push the green ON-switch (1).
• Start the machine by pushing the Foot pedal switch (10) with your foot.
To stop the machine, release the Foot pedal switch (10). Push the red OFF-switch (1) to turn the machine off.
1. On/off switch
3. Speed adjustment knob
13. Operation switch
EN
Fig. A1
3
1
13