Operation Manual

ManualsBrandsFerm ManualsSawBSM4007 - FLZ-275

Ferm BV • P.O. Box 134 • 8280 AC Genemuiden • NL • www.ferm.com 0210/24

Ferm Band Saw

FLZ-275

USER’S MANUAL

Art.nr. 730762

Screwfix Art.nr. 18772

UK Subject to change

Document Ref:

FLZ-275/18772/PMR28/Issue 1/April 02

These instructions are the sole property of Ferm-Omega Tools and may not be reproduced

Summary of content (6 pages)

PAGE 1
UK Subject to change USER’S MANUAL Document Ref: FLZ-275/18772/PMR28/Issue 1/April 02 Copyright © These instructions are the sole property of Ferm-Omega Tools and may not be reproduced Ferm Band Saw FLZ-275 Art.nr. 730762 Screwfix Art.nr. 18772 Ferm BV • P.O. Box 134 • 8280 AC Genemuiden • NL • www.ferm.
PAGE 2
8. Adjustment knob 9. Sawdust outlet 10. Blade guides 11. Table 12. Table tilt groove 13. Graduated scale 14. Pointer 15. Table locking knob FERM BAND SAW FLZ-275 USERS MANUAL TECHNICAL SPECIFICATIONS Voltage Frequency Power input No load speed Discharge Max. Cutting capacity 90° Table dimensions Weight Lpa (sound pressure) Lwa (acoustic power) Vibration | | | | | | | | | | | SAFETY INSTRUCTIONS 230 V~ 50 Hz 350 W 1300/min 190 85 mm 290 x 290 mm 17 kg 76.8 dB(A) 87.56 dB(A) 5.
PAGE 3
SPARE PARTS LIST AAA-000 REF NR 13 16 19 36 50 79 105 112 120 130 DESCRIPTION CAPACITOR (8 µF) SPARE SAW BLADE (1.
PAGE 4
BEFORE USING THE BAND SAW The saw is for bench use only. Do not use outdoors. This saw is intended for use on wood, wood derived products, plastics and soft materials/metals. This saw must be fully assembled before use. ASSEMBLING/MOUNTING THE BAND SAW Make sure the saw is switched OFF and unplugged from mains. • • screw with the 3mm wrench as shown in Fig 3. Tighten clamp lever (B) and check the angle again – readjust a necessary.
PAGE 5
Sawdust builds up inside the saw • Clean saw chamber regularly. • Connect a dust extractor to the port beside motor. The blade cannot be positioned on the wheels • The wheels are out of alignment due to a faulty bearing. Take to your Ferm dealer for repair. • Adjust tracking as previously described. There are no user serviceable/repairable parts in this unit. Qualified service engineers must carry out repair and servicing. MAINTAIN TOOLS WITH CARE Keep the tool clean for better and safer performance.
PAGE 6
It is important that these adjustments are correct. The upper/lower thrust bearing support the blade and the saw will only work efficiently when the blade is supported by both of them. To adjust the blade guides • Loosen the Allen bolts (A in Fig 10) with the 3mm wrench. • Move both guides (B) evenly towards the blade – make sure they are as close as possible without touching the blade. • Tighten the bolts to secure. • Replace saw table as previously described.