User's Manual

OBID
®
me
g
alock-l
Installation
FEIG ELECTRONIC GmbH Page 9 of 12 M81291-7e-ID-B.DOC
5.3. Resetting a
megalock-l
with the "ResetKey"
Clearing a megalock-l may be necessary for example if a mistake was made in initializing (e.g.
wrong cabinet number) or if a megalock-l needs to have a different configuration.
NOTE
The ResetKey is only accepted by the megalock-l if it is unlocked!
The megalock is reset in the following way:
1. Activate
megalock
(push rotary knob)
2. You have 8 seconds to hold the ResetKey in front of the rotary knob in the sensing zone
of the megalock-l antenna.
Once the parameters in the megalock-l have been cleared, the megalock-l acknowledges
the process by causing the green LED to come on for a brief time followed by simultane-
ous flashing of the green and red LED.
3. Now the megalock-l can be reconfigured with a SetupKey
(see: 5.2. Configuring the megalock-l with the "SetupKey").
5.4. Replacing a
megalock-l
If it becomes necessary to replace a megalock-l, the new megalock-l must first:
1. be configured with the
megalock
number and other parameters using the SetupKey
(see: 5.2. Configuring the megalock-l with the "SetupKey") and
2. be actuated with a MasterKey to ensure that the new megalock-l accepts only MasterKeys
having the currently valid MasterKey-Generation.