User's Manual

Liberator-V1000 User Manual Rev 04v05
Page 13 of 85 FBN Doc #: FBN-0125_04v05
Figure 7 – Alignment Bracket
2.3.3 PoE
++
Injector
The terminal is powered via an Ethernet cable with a high-power Power-over-Ethernet power supply
conforming to “Ultra-PoE” or “PoE
++
” specifications. It is recommended that the Sub10 Systems PoE
++
power
injector should always be used to power the Liberator-V1000. If the correct power supply is not used, this
may invalidate the safety certification and cause a safety hazard. The mains power supply is the primary
disconnect device for the Liberator-V1000. The installer must ensure that a mains voltage supply cable
approved for the country of installation is used.
WARNING: It is strongly advised to first disconnect any network cable attached to the “IN” port of the PoE
++
supply before:
 Connecting or disconnecting the PoE
++
supply from the mains power.
 Connecting or disconnecting the CAT5e cable between the PoE
++
supply and the radio terminal (ODU).
Should the network equipment connected to the Liberator-V1000 Link not offer PoE
++
, a power injector can
be inserted in-line with the Ethernet cable.
Figure 8: (a) SL Power PENT 1040B PoE
++
power injector (b) PhiHong POE61W PoE
++
power injector
2.3.4 Mast Bracket
The mast bracket is used to mount the bracket onto a mast. The bracket is suitable for any pole diameter from
50 mm to 115 mm (2” to 4.5”).