Third Party Verification Claim
IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a
combination of both to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the
supplier's factory and warehouses as well as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in
the characteristics below and is not to be construed as any recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product
acceptance by Authorities Having Jurisdiction.
This listing period is based upon the last date of the month indicated on the Effective Date and Void After Date shown above. Any change in material,
manufacturing process, marking or design without having first obtained the approval of the Product Certification Committee, or any evidence of
non-compliance with applicable codes and standards or of inferior workmanship, may be deemed sufficient cause for revocation of this listing.
Production of or reference to this form for advertising purposes may be made only by specific written permission of IAPMO Research and Testing, Inc.
Any alteration of this certificate could be grounds for revocation of the listing. This document shall be reproduced in its entirety.
This certificate is not evidence of current listing. To verify listing status, visit the IAPMO R&T
Product Listing Directory at pld.iapmo.org
Effective Date: April 2019 Void After: April 2024
Product: Ceramic Plumbing Fixtures File No. 6004
Issued To: Changie Ceramic(hk) Industrial Co., Ltd.
Room 2202, 22/f, Austin Square
No 83. Austin Road, Kowloon
Hong Kong,
China
Identification: Ceramic Plumbing Fixtures shall be marked with the manufacturer's name
or registered trademark, or in the case of private labeling, the name
of the customer for whom the fixture was manufactured. Markings shall
be permanent, legible, and visible after installation.
The model number of close-coupled water closets shall be marked on both
the tank and the bowl.
Water closets and urinals shall be marked to identify the average water
consumption, expressed in litres and gallons per flush. The litre or
gallon value may be stated first, at the manufacturer's option.
Gravity flush tanks shall be marked with a water level mark or with the
information necessary to determine the water level in the tank needed
to deliver the intended flush volume. This mark shall be applied to the
ceramic body of the tank, the tank liner, or the flush valve overflow