Wine Cooler Universal Installation Instructions and Use & Care Guide Model: JDW-90B IMPORTANT: READ AND SAVE THESE INSTRUCTIONS. FOR RESIDENTIAL USE ONLY.
TABLE OF CONTENTS Your Wine Cooler……………………………….…..3 Technical Data………………………………….…..3 Important Safety Instructions………………………4 Installation Instructions……………………….……5 Electrical Connection………………………..….…..5 Operating Your Wine Cooler………………………..6 Care And Maintenance………………………………6 Troubleshooting……….…………………….……….
Your Wine cooler 1. 2. 3. 4. 5. 6. 7. 8. Right upper Hinge Upper zone Light Fan Upper zone NTC point Exhaust window Lower zone temperature Upper zone temperature Temperature switch 9. Light switch 10. Carbon filter 11. Lower zone Fan 12. Lower zone Light 13. Shelf 14. Lower zone NTC point 15. Exhaust window 16. Foot 17. Door seal 18. Glass 19. Lock Technical Data Model No. J DW - 90B Capacity 90L Voltage 110V Rated Current 1.
Electro Circuit Control Diagram TRANSFORMER PTC HEATER COMPRESSOR θ θ PLUG CONTROL PCB θ θ M M M M DISPLAY PCB SERNSOR1 SERNSOR2 LIGHT FAN1 FAN2 FAN3 FAN4 Important Safety Instructions To reduce the risk of fire, electrical shocks, or injury when using your wine cooler, please follow these basic precautions. PLEASE READ all instructions before installing, operating, or servicing the appliance.
Installation Instructions Before using your wine cooler Remove the exterior and interior packaging Check to be sure the following parts are included: For JDW-90B, (5) five removable shelves. Instruction manual. Before connecting the wine cooler to power source, let it stand upright for approximately 24 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. Clean the interior surface with lukewarm water using a soft cloth.
Operating Your Wine cooler How to use the press-buttons on the Display Panel: To control the upper zone temperature, press UP or DOWN button on the left side. Each press would adjust the temperature by 1°C between 5~10°C or 1°F between 40~50°F. To control the lower zone temperature, press UP or DOWN button on the right side. Each press would adjust the temperature by 1°C between 10~18°C or 1°F between 50~66°F. To turn on or off the internal LED lighting, press LIGHT button on the right side.
Troubleshooting You can solve many common wine cooler problems easily, saving you the time or cost of a possible service call. Here are some common problems and their respective solutions. PROBLEM POSSIBLE CAUSE Wine cooler does not operate. Not plugged in. Plugged into an outlet not providing 110V/120V. Breaker fuse tripped. Wine cooler is not cold enough. Check the temperature control setting. External environment may require a higher setting. The door is open too often.