Use and Care Manual

ManualsBrandsFahrenheat ManualsGarage Heaters1,500-Watt Toe Space Electric Heater with Built-In Thermostat

S Series

Electric Toe Space Heaters

Without Built-in Thermostat

Dear Owner,

Congratulations! Thank you for purchasing this new heater manufactured by Marley Engineered

Products. You have made a wise investment selecting the highest quality product in the heating indus-

try. Please carefully read the installation and maintenance instructions shown in this manual. You

should enjoy years of efficient heating comfort with this product from Marley Engineered Products... the

industry’s leader in design, manufacturing, quality and service.

... The Employees of

Marley Engineered Products

Read Carefully - These instructions are written to help

you prevent difficulties that might arise during installation

of heaters. Studying the instructions first may save you

considerable time and money later. Observe the following

procedures, and cut your installation time to a minimum.

To reduce risk of fire or electric shock:

1. To prevent electrical shock, disconnect all power coming to

heater at main service panel before wiring or servicing.

2. All wiring must be in accordance with the National and Local

Electrical Codes and the heater must be grounded as a pre-

caution against possible electric shock.

3. Verify the power supply voltage coming to heater matches the

ratings printed on the heater nameplate before energizing.

4. This heater is hot when in use. To avoid burns, do not let bare

skin touch hot surfaces.

5. DO NOT INSTALL THIS HEATER UNDER CABINETS

MADE OF VINYL OR COATED WITH VINYL.

6. Do not insert or allow foreign objects to enter any ventilation

or exhaust opening as this may cause an electric shock,

fire,or damage to the heater.

7. To prevent a possible fire, do not block air intakes or exhaust

in any manner. Keep combustible materials, such as crates,

drapes, etc., away from heater. Do not install behind

doors, furniture, towels, or boxes.

8. A heater has hot and arcing or sparking parts inside. Do not

use it in areas where gasoline, paint or flammable liquids are

used or stored.

9. Use this heater only as described in this manual. Any other

use not recommended by the manufacturer may cause fire,

electric shock, or injury to persons.

10. This heater is not approved for use in corrosive atmospheres

such as marine, green house or chemical storage areas.

Installation & Maintenance Instructions

WARNING

FILE #E21609

SAVE THESE INSTRUCTIONS

Summary of content (12 pages)

PAGE 1
FILE #E21609 S Series Electric Toe Space Heaters Without Built-in Thermostat Installation & Maintenance Instructions Dear Owner, Congratulations! Thank you for purchasing this new heater manufactured by Marley Engineered Products. You have made a wise investment selecting the highest quality product in the heating industry. Please carefully read the installation and maintenance instructions shown in this manual.
PAGE 2
! Connect the blue leads with wirenuts (provided) to thermostat lead wires. 6. FOR REMOTE 2 POLE WALL THERMOSTAT, WIRE HEATER AS SHOWN IN FIG.4. Run field wiring from circuit breaker box to wall thermostat. Connect blue lead A with heater to field supply lead from load side of thermostat. Connect supply field wiring from thermostat to two black pigtail leads for 240/208V model or to black and white pigtail leads for 120V model with wirenuts (provided).
PAGE 3
SPECIFICATIONS Fig. 4 Wiring For Remote Thermostat (See Caution Statement And Note Below This Diagram) Temperature cycled pole Model No Wattage Voltage Amperage S1500B 1500 750 120 12.5 6.3 S1504B 1500/1126 750 / 563 S1100B 1125 563 120 9.4 4.7 S1104B 1125/844 563 / 422 240 / 208 4.7 / 4.1 2.3 / 2.0 Manual On-Off pole L2 or N L1 Remote double-pole wall thermostat This lead supplies the motor and must not be cycled by the thermostat 6.3 / 5.4 3.1 / 2.
PAGE 4
NAMEPLATE MODEL NO. S1504B DATE CODE FAN FORCED WALL HEATER 240 1500/750 VOLTS AC WATTS 0606 6.3/3.1 AMPS CAUTION: USE ONLY WITH TS ENCLOSURE. DO NOT OPERATE WITHOUT GRILLE IN PLACE. ATTENTION: UTILISER UNIQUEMENT AVEC UN BOÎTIER TS. NE PAS FAIRE FONCTIONNER SANS LA GRILLE. PRECAUTION: USARLO SÓLO CON LA CUBIERT A TS. NO DEBE ENCENDERSE SIN LA REJILLA.
PAGE 5
REGISTRO Nº E21609 Serie S Calefactores eléctricos a ras del piso sin termostato incorporado Instrucciones de instalación y mantenimiento Estimado propietario: ¡Felicitaciones! Gracias por comprar este nuevo calefactor fabricado por Marley Engineered Products. Al seleccionar el producto de más alta calidad de la industria de calefacción, usted ha hecho una sabia inversión. Por favor, lea cuidadosamente las instrucciones de instalación y mantenimiento incluidas en este manual.
PAGE 6
! Quite las tuercas de empalme de cables que sujetan los dos conductores azules. Conecte los conductores azules con tuercas de empalme de cables (provistas) a los cables de conexión del termostato. ADVERTENCIA PARA REDUCIR EL RIESGO DE INCENDIO O DE CHOQUE ELÉCTRICO, NO INSTALE LA UNIDAD SIN LA CAJA POSTERIOR. NO HAGA FUNCIONAR EL CALEFACTOR SIN HABER INSTALADO LA REJILLA. ATENCIÓN 6. CON UN TERMOSTATO DE PARED REMOTO DE 2 POLOS, CABLEE EL CALEFACTOR COMO SE MUESTRA EN LA FIG. 4.
PAGE 7
ESPECIFICACIONES Fig.
PAGE 8
PLACA DE CARACTERÍSTICAS MODEL NO. S1504B DATE CODE FAN FORCED WALL HEATER 240 1500/750 VOLTS AC WATTS 0606 6.3/3.1 AMPS CAUTION: USE ONLY WITH TS ENCLOSURE. DO NOT OPERATE WITHOUT GRILLE IN PLACE. ATTENTION: UTILISER UNIQUEMENT AVEC UN BOÎTIER TS. NE PAS FAIRE FONCTIONNER SANS LA GRILLE. PRECAUTION: USARLO SÓLO CON LA CUBIERT A TS. NO DEBE ENCENDERSE SIN LA REJILLA.
PAGE 9
FILE #E21609 Série S Radiateurs électriques pour retrait de socle livrés sans thermostat intégré Instructions d'installation et d'entretien Cher client, Félicitations ! Merci d'avoir acheté ce nouveau radiateur fabriqué par Marley Engineered Products. Vous avez fait un sage investissement en sélectionnant un produit de la plus haute qualité dans l'industrie du chauffage. Veuillez lire avec soin les recommandations d'installation et d'entretien données dans ce manuel.
PAGE 10
! 6. EN CAS DE THERMOSTAT MURAL BIPOLAIRE, CÂBLER LE RADIATEUR COMME MONTRÉ EN FIG. 4. Faire passer le câblage local depuis le disjoncteur secteur jusqu’au thermostat mural. Brancher le fil bleu A du radiateur avec le fil d’installation locale venant de la sortie de charge du thermostat.
PAGE 11
SPÉCIFICATIONS Fig.
PAGE 12
PLAQUE SIGNALÉTIQUE MODEL NO. S1504B DATE CODE FAN FORCED WALL HEATER 240 1500/750 VOLTS AC WATTS 0606 6.3/3.1 AMPS CAUTION: USE ONLY WITH TS ENCLOSURE. DO NOT OPERATE WITHOUT GRILLE IN PLACE. ATTENTION: UTILISER UNIQUEMENT AVEC UN BOÎTIER TS. NE PAS FAIRE FONCTIONNER SANS LA GRILLE. PRECAUTION: USARLO SÓLO CON LA CUBIERT A TS. NO DEBE ENCENDERSE SIN LA REJILLA.