Installation Guide

SPECS:
- Upper Section Weight: 70 lbs. typ.
- Base Section Weight: 120 lbs. typ.
- Stack Height: Approx. 54” (as shown)
- Base: 22” Diameter
- Load Rating: 135,000 lbs. at top
- 60” or 72“ x 1/2” galv. anchor rod with base
plate, top washer and nut
INSTALLATION:
Dig hole or trench to the required depth
(below frost line).
Prep bottom with crushed stone as
necessary.
Thread anchor rod through base section.
Place base and anchor into position.
Add upper sections by sliding over anchor
rod.
Use 3000 psi (minimum) mortar between
each layer.
Level, plumb & align as necessary.
Backfill, compacting soil every six inches.
You’re done! Keep building.
Upper
Section
12”
11”
8
1/2
”
Base
8”
22”
Center Hole for Anchor Rod
Typical EZ-TUBE Stack with Base
Section & Four Upper Sections
Approx.
1/2” dia. galv.
threaded anchor rod
54”
EZ-CRETE.COM
DOWNLOAD FULL SPECS
& INSTRUCTIONS AT
EZ-TUBE
INSTALLS BY HAND — READY TO BUILD ON IN MINUTES
EZ-CRETE.COM
FOR MORE DETAILS, INSTRUCTIONS AND A LIST OF DISTRIBUTORS, VISIT:
EZ-CRETE.COM