- Extron Electronics Mini Video Switcher User's Guide
VersaTools
®
MSW 4V & 4SV • Installation and Connections
VersaTools
®
MSW 4V & 4SV • Installation
VersaTools
®
MSW 4V & 4SV, cont’d
A/V
SWITCHER
A
U
T
O
S
W
IC
H
M
OD
E
NORM
AL
AUTO
1
2
3
4
Extron
MSW 4V
Extron
PMK 250
Projector Mount Kit
Extron
Power Supply
Plastic Tie
Cover Sheet
Front Plate
Figure 5 — Projector mounting the MSW with a PMK 250
For the PMK 100, mount the MSW as follows:
1. If necessary, remove the feet from the bottom of the MSW.
2. Attach the mounting brackets to the MSW with the
machine screws provided (figure 6).
3. Secure the MSW to a projector mount or other surface by
inserting the mounting bolt through the bracket’s slotted
hole.
Ceiling
Digital Projector
PMK 100 Projector
Mounting
Bracket
MDA 4V SD
I
POW
ER
1
5
V
.5
A
M
A
X
1
2
3
4
SD
I
I
N
P
UT
SD
I
O
U
TP
U
TS
Mounting
Bolt
Projector Mounting
Figure 6 — Projector mounting the MSW with a PMK 100
VersaTools
®
MSW 4V & 4SV • Installation
Furniture mounting
Furniture mount the MSW using the optional MBU 123
VersaTools
®
under-desk mounting kit (part #70-212-01) as follows:
1. If necessary, remove the feet from the bottom of the MSW.
2. Attach the mounting brackets to the MSW with the
machine screws provided (figure 4).
A/V SWITCHER
MODE
NORMAL
AUTO
AUTO
SWITCH
1
2
3
4
Figure 4 — Furniture mounting the MSW
3. Hold the MSW with the attached brackets against the
underside of the table or other furniture. Mark the
location of the screw holes of the bracket on the mounting
surface.
4. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
5. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" of the screw head protrudes.
6. Align the mounting screws with the slots in the brackets
and place the MSW against the surface, with the screws
through the bracket slots.
7. Slide the switcher slightly forward or back, then tighten all
four screws to secure the MSW in place.
Projector mounting
Projector mount the MSW using the optional PMK 100
(part #70-217-01), PMK 250 (part #70-562-02), or PMK 350
(part #70-563-02) under desk mounting kit.
For the PMK 250 or PMK 350, follow the instructions included
with the kit (figure 5).
54 VersaTools
®
MSW 4V & 4SV • Installation