User's Manual
MVX VGA A Matrix Switchers • Remote Control
Remote Control
MVX VGA A Matrix Switchers • Remote Control
4-34-2
Refer also to the MVX VGA A User’s Manual at www.extron.com. Refer also to the MVX VGA A User’s Manual at www.extron.com.
Selected SIS Commands
The switchers have Simple Instruction Set (SIS
™
) commands
that you can use for operation and configuration. You can run
these commands from a PC connected to either of the switcher’s
serial ports. See f (page 2-3) and h (page 2-4), for connection
information.
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional description
Create ties
N
• Commands can be entered back-to-back in a string, with no spaces. For example: 1*1!02*02&003*003%4*8$.
•
The matrix switchers support 1-, 2-, and 3-digit numeric entries (1*1!, 02*02&, or 003*003%).
N
When you create a tie where X! = 00, you tie no input to the specified output (X@) (untie X@).
N
The & tie command for RGB and the % tie command for video can be used interchangeably.
N
The & read tie command for RGB and the % read tie command for video can be used interchangeably.
Tie input X!
to output
X@
, video
and audio
X!*X@! OutX@•InX!•All] Tie input X!‘s video and audio to output X@.
Example:
1*3!
Out03
•In01•All]
Tie input 1 video and audio to output 3.
Tie input
X!
to output
X@
, RGBHV
X!*X@& OutX@•InX!•RGB]
Tie RGB only (video breakaway).
Example
(see 3rd Note, above):
10*4&
Out04
•In10•RGB]
Tie input 10 RGB to output 4.
Tie input
X!
to output
X@
, video
X!*X@% OutX@•InX!•Vid]
Tie video only (video breakaway).
Example
(see 3rd Note, above)
7*5%
Out05
•In07•Vid]
Tie input 7 video to output 5.
Tie input
X!
to output
X@
, audio
X!*X@$ OutX@•InX!•Aud]
Tie audio only (audio breakaway).
Example:
12*04$
Out04
•In12•Aud]
Tie input 12 audio to output 4.
Read RGB output tie
X@& X!] RGBHV input X! is tied to output X@.
Read video output tie
X@% X!] Video input X! is tied to output X@.
Read audio output tie
X@$ X!] Audio input X! is tied to output X@.
N
X! = Input number
00 –
(maximum number of inputs for your model)
(00 = untie)
X@ = Output number 01 – (maximum number of outputs for your model)