User's Manual

HSA 200/222 Series • Maintenance and Modifications

Maintenance and Modifications, cont’d

2. (HSA 222 models only) Remove the four Phillips head

screws from the front access panel (figure 3-1). Retain the

screws. Lift the panel away from the enclosure.

Remove

front access

panel.

Figure 3-1 — Removing the front access panel

(HSA 222 models)

3-53-4

3. (HSA 222 models only) Disconnect both RJ-45 connectors

from the underside of the enclosure by simultaneously

performing steps 3a and 3b:

a. With a Tweeker in one hand, reach through the small

access hole in the front of the enclosure (figure 3-2)

and gently pry outward on the front of the RJ-45

connector detent on the bezel plug-in,

— while you —

b. Reach your other hand through the front panel access

hole and tilt the connector back.

This disconnects the connector from the interior of the

lower enclosure without damaging the bezel plug-in.

Figure 3-2 — Releasing the bezel plug-in detent

(HSA 222 models)