Use and Care Manual

ASSEMBLY

Step 3

Warning: The hardware should be installed as shown in the illustration above.

3A. Installing the Backrest - Slide the brackets of the Bed Frame (3) onto the Right & Left Pivot

Arm (5) & (4). Aligning the holes of the Right & Left Pivot Arm (5) & (4) with the bracket holes of

the Bed Frame (3). Secure with two Hex Bolts (65), two Bolts (70), two Flat Washers (86), and

two Lock Nuts (83). Tighten the Hex Bolts (65) with the 6mm Allen Wrench and the Hex Wrench

provided. Tighten the Hex Bolts (67) and Lock Nuts (83) with the 6mm Allen Wrench provided.

Note: Fig. A shows a correctly installed Pivot Arms (4) & (5) on the Bed Frame (3) brackets.

(65) Hex Bolt

2 PCS

(70) Bolt

2 PCS

(86) Flat Washer

2 PCS

(83) Lock Nut

2 PCS

Hardware:

Hex Wrench

1 PC

5mm Allen Wrench

1 PC

Tools:

6mm Allen Wrench

1PC

Fig. A