TB220X-AB 24” TOOL CHEST AND ROLLER CABINET
1 Caster 4 4 M6 Nut 2 Caster Holder 4 5 Side Handle 2 3 M6 x 12 Bolt 16 6 M4 x 6 Screw 8 PARTS LIST 16 5 6 2 3 4 Tools needed for Assembly Rubber Mallet Screwdriver Wrench (7/16 inch) 1
ASSEMBLY INSTRUCTIONS 1. Place the cabinet into an upside down position. Remove the 2pcs plastic inserts as shown in diagram A. Lift up and pull out the 8pcs plastic brackets as shown in diagram B. Retain 4 caster holders (#2) for later assembly in step 4. Discard the plastic inserts and plastic brackets. A B 2. Remove the base from the cabinet.
ASSEMBLY INSTRUCTIONS 3 058-1362-6 3. Separate the chest from the base by removing the four screws that connect the chest to the base. Discard the screws. 4. Attach the caster holders (#2) and the base back to the cabinet with included 16pcs M6 x 12 bolts (#3) and M6 nuts (#4). Please carefully tap the four casters (#1) into the caster holders (#2) with rubber mallet.
ASSEMBLY INSTRUCTION 4 5. Attach the two side handles (#5) to the chest using 8pcs M4 x 6 screws (#6). 6. Reposition the roller cabinet into the upright position, place the chest on top of the roller cabinet.
5 SAFETY WARNINGS Read and follow all instructions before using this product INSPECT this product before use. Do not use the product if you notice loose or damage parts. LOAD the cabinet from the bottom up. Failure to load the cabinet from the bottom up may cause the product to tip, which could cause personal injury and product damage. DO NOT open more than one drawer at one time.
