Installation Guide

4
www.surewood-lnl.com © 2013 SureWood-LNL All Rights Reserved
W
OOD
~
LNL
TERMINOLOGY AND DESIGN
Handrails in post-to-
post newel systems
attach to block-top or
box newels.
These types of
handrail systems
require few, if any rail
fittings.
Handrails are attached
to newels using
screws, nails or rail
bolts.
Generally, these rail
systems are easier to
assemble and can be
less expensive when used with common newel posts.
To construct a post-to-post handrail system, you will
need the following types of newels, depending on the
configuration of your staircase. Using the diagram
below, the newels you would need are:
A. Starting Newel
B. Landing Newel
C. Rosette
D. Half Newel
There are two basic types of handrail systems. “Post to Post” and “Over the Post. The type of newel
posts you choose will determine your handrail style. However, you may select any baluster type
(metal, pin-top wood, square-top wood) and use it with an over-the-post or post-to-post rail system.
Handrails in over-the-
post newel systems
travels over the newel
posts, allowing the
hand to run along the
handrail continuously.
These systems require
handrail fittings that fit
on top of newel posts.
Handrails are attached
to fittings using rail
bolts.
Over-the-post systems
are generally more
expensive and labor
intensive.
Constructing an over-the-post handrail system requires
specific types of rail fittings that are unique to the
configuration of your staircase. Using the diagram
below, the most commonly used newels and fittings are
listed.
A.
Starting Newel
B. Landing Newel
C. Rosette
D. Straight Gooseneck (fitting)
E. 90
o
Gooseneck (fitting)
F. 180
o
Gooseneck (fitting)
G. Starting Fitting (volute or starting easing)
POST TO POST OVER THE POST