INSTRUCTION MANUAL Digital Video Recorder EDSR-900, EDSR-1600

Appendix-D
62
Alarm I/O pin assignment
The alarm connector, Figure 1, is used to provide one sensor alarm input for each camera input.
For easy operation, an alarm extension board, Figure 2, is provided to connect to the alarm connector.
Each alarm input requires two wires, one wire connects to the desired alarm input pin, the second wire
connects to the ground.The alarm signal assignment is shown at the following.
<Figure 1>
<Figure 2>
25
2
1 13
D-SUB 25 pin female connector (DVR)
PR16D00400 Alarm extension board
1 2 3 4 5 6 7 8 9 10 11 12 13 14
PR16D00400
28 27 26 25 24 23 22 21 20 19 18 17 16 15
DVR
* ALM10~ALM16 are active only for EDSR-1600
PIN # NAME
1 GND
2 ALM 1
3 ALM 2
4 ALM 3
5 ALM 4
6 ALM 5
7 ALM 6
8 GND
9 ALM 7
10 ALM 8
11 ALM 9
12 ALM 10*
13 ALM 11*
14 ALM 12*
15 ALM 13*
16 ALM 14*
17 ALM 15*
18 ALM 16*
19 ALMRST
20 REC-IN
21 GIN
22 SPARE-IN
23 DISKFULL
24 SPARE-OUT
25 ALM-N.C
26 ALM-N.O
27 ALM-COM
28 GND
HOST
PIN # NAME / Function
1 GND Ground
2 ALM 1 Alarm In 1
3 ALM 2 Alarm In 2
4 ALM 3 Alarm In 3
5 ALM 4 Alarm In 4
6 ALM 5 Alarm In 5
7 ALM 6 Alarm In 6
8 ALM 7 Alarm In 7
9 ALM 8 Alarm In 8
10 ALM 9 Alarm In 9
11 ALM 10* Alarm In 10
12 ALM 11* Alarm In 11
13 ALM 12* Alarm In 12
14 ALM 13* Alarm In 13
15 ALM 14* Alarm In 14
16 ALM 15* Alarm In 15
17 ALM 16* Alarm In 16
18 ALMRST Alarm Reset
19 REC Record In
20 GIN10 Reserved
21 DISKFULL Disk Full Out
22 GO1 Reserved
23 ALM-N.C Alarm Out N.C.
24 ALM-N.O Alarm Out N.C.
25 ALM-COM Alarm OUT COM