Installation Guide

Setting Up the Canopy
2
□
3
ATTACHING THE LARGE CANOPY
□
□
Unfold the canopy and place on top of the canopy
frame.
Secure the canopy top to the corners of the canopy
frame using the Velcro connections.
LOCKING THE CANOPY
Under the canopy, place one hand on the upper frame
and use the other hand to push the central hub straight
up until it clicks into the central pole.
Finish attaching the large canopy inside the canopy
frame using the Velcro loops.
4
□
5
ADJUSTING THE CANOPY HEIGHT
□
Press the red button on each leg and raise or lower
to adjust the canopy height.
SECURING THE CANOPY IN PLACE
Insert a stake into the foot of each canopy leg.
□
Measure out each leg to a proper distance and secure four stakes to the ground. Attach the ropes to the canopy
top and tie the attached ropes to the stakes in the ground. Ensure the ropes have the proper tension by
adjusting the plastic adjusters on the ropes.
Use and Care Guide
Texas Flag Canopy
10 ft. x 10 ft.
Item # HD-TX100
Model #000000000
Taking Down the Canopy
1
REMOVING THE STAKES AND RETRACTING THE LEGS
□
Pull up all stakes from the ground.
□
Press the push button on each leg and retract
the legs to their original height.
2
UNLOCKING THE CANOPY
□ Go under the canopy, press the red lock button.
Pull down the central hub until it is separated
from the central pole.
3
FOLDING THE FRAME
□ Lift one leg of the frame until the two neighbouring
legs are raised off the ground. Push inward until
the frame is fully closed.
4
PACKING THE CANOPY IN THE STORAGE BAG
□ With the canopy feet facing the rollers, slide
the wheeled storage bag over the closed
canopy frame.
□
Close the zipper on the wheeled storage bag.
Safety Information
Please read and save these instructions before attempting to set up this tent.
CAUTION:
up and take down.
CAUTION: Never set up or continue to use in any rain, wind, or storm
conditions, especially lightning storms. Damage can occur to the tent
and put you and others in potential danger.
CAUTION: Avoid setting up the tent on steep inclines.
CAUTION: Do not use this tent for permanent shelter. It is designed
for temporary use only.
CAUTION: Never leave the tent unattended.
This product contains composite wood that complies with Phase 2 of CAATCM 93120 for formaldehyde.
Manufacture ID: Guangxi Gaolin Forestry Inc. 11/26/2018
TSCA Title VI Compliance
Spare Parts
To inquire about replacement parts, please call: 1-888-502-9589, Monday-Friday, 9:00AM - 5:00PM Central Time.
A
A
C
F
B
D
G
K
L
E
H
J
I
F
G
M
N
B D E
I
L
J K
H
C
Part Description
Reference No.
A
Central Pole
SP221
B Central Bottom Hub SP002
C
Leg Cap
SP003
D
Top Bracket
SP004
E Slider SP005
F
Ceiling Assembly
SP006
G Eave Assembly SP007
H
Leg Assembly
SP262
I
Leg Extend
SP163
J Plastic Foot SP010
K M5 Bolt Kit SP011
L
Canopy Top
SP263
M
M4 Bolt Kit
SP228
N Wheeled Storage Bag SP264
Texas Flag Canopy Manual Size: 42x19.5cm
Part Description
Reference N0.
□
Drain Holes
1
OPENING THE CANOPY FRAME
□ With two persons on the diagonal ends, lift and partially
pull the canopy frame apart.
WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS
TENT FABRIC.
This tent meets the flammability requirements of CPAI-84. The fabric may
burn if left in continuous contact with any flame source.
This canopy is not fire proof. The application of any foreign substance to
the tent fabric may render the flame-resistant properties ineffective.