Use and Care Manual

15 WWW.HOMEDEPOT.COM
Please contact 1-844-241-5521 for further assistance.
Deep Well Installation (continued)
14
Connecting the brass elbow to
the pressure regulator
15
Connecting the PVC adaptor to
the pressure regulator
 Thread the 1/4 in. disassembled elbow insert into the 1/4 in. hole
on the side of the pressure regulator.
 Slide the pressure tubing (attached with the pump pressure
switch or included in regulator kit) over the 1/4 in. brass elbow
and the pressure switch connector.
 Wrap thread tape around the threads of a 3/4 in. MNPT x 1 in. slip
PVC adaptor (sold separately).
 Thread the adaptor into the pressure regulator.
16
Connecting a tank tee to the
pressure tank
17
Checking the pressure in the
tank
 Wrap all threads with thread tape.
 In order for the pump and the pressure tank (sold separately) to
operate properly, the pressure tank needs to be drained of all
water BEFORE INSTALLING IT TO THE PUMP.
 Thread a 10 in. tank tee (sold separately) or another necessary
size tee into the pressure tank.
 Plug one outlet on top of the tank tee with a 1/4 in. plug (sold
separately) and install a pressure gauge (sold separately) on the
other outlet on top of the tank tee.
 Thread two 1 in. female PVC adaptors (sold separately) onto the
two inlet sides of tank tee.
 Thread a 1/2 in. relief valve and a 1/2 in. drain valve (both sold
separately) to the front of the tank tee.
 Air pressure in the tank must be 2 psi lower than the "cut-in" of
the pressure switch.
NOTE: The pump has a 30/50 psi pressure switch, which means
the "cut-in" is 30 psi; therefore, the tank needs to be set to 28
psi. To check the pressure in the tank, use a tire pressure gauge
(not included). If more air is needed, add air to the tank with a tire
pump or air compressor. If less is needed, bleed out some air.