Use and Care Manual

Deep Well Installation (continued)

Attaching the nozzle and venturi

to the ejector

Connecting the foot valve to the

ejector

 Wrap the threads of the venturi tube (B) (J32P-18/#11) with

thread tape.

 Attach the O-ring (D) on the nozzle (C) (#02) and screw the nozzle

 Attach the venturi tube (B) (J32P-18/#11) with the nozzle (C) and

O-ring (D) to the Ejector.

 Wrap both ends of a 1-1/4 in. x 3 in. nipple (sold separately)

with thread tape (sold separately).

 Thread the nipple into 1-1/4 in. foot valve (sold separately).

 Thread the other end of the nipple into the bottom of the

ejector.

 Hand tighten, and then tighten 1-1/2 turn with a pipe wrench.

Connecting the rigid pipe to the

ejector

Sliding the pipe assembly into

the well

 Connect two pipes (1 in. drive, 1-1/4 in suction) to the ejector.

NOTE: If use PVC pipe to connect, a 1 in. x 3 in. nipple is

required.

 Before sliding the pipe assembly into the well, firmly clamp the

assembly with a pipe clamp (not included) to prevent the

assembly from sliding down into the well.

 Keep the 1 in. pipe 2 in. shorter than the 1-1/4 in. pipe.