Use and Care Manual

ManualsBrandsEverbilt ManualsAppliance partsRemovable Splash Guard and Stopper Set for 3-Bolt Garbage Disposals

NOTE: As the mounting assembly is

properly assembled at the factory,

please pay close attention to the

order of the mounting system parts.

LOWER MOUNT RING

DISPOSER

DISHWASHER INLET

CUSHION RING

MOUNT TAB

Removable Splash Guard

Sink Flange

Plumber’s Putty (not included)

Sink

Upper Mount Ring

Mounting Screw

Retainer Ring

Cushion Ring

Lower Mount Ring

Rubber Gasket

Fiber Gasket

Support Flange

Elbow Flange & Screw Set (2)

Elbow

Spring Clamp Ring

Elbow

Groove

EB1250-HT

MODEL ONLY

* Part not disengaged

during disposer

installation.

STOPPER

REMOVABLE SPLASH GUARD

(

Not

hown-Extended

Ink Flange.

1”

Longer

)

RT FLAN

PPER M

NT RIN

MOU

REW

RETAINER RIN

CUSHION RING*

WER M

NT RIN

FIBER

KET

NETI

H RIN

TTA

HMENT IN

DED WITH

DEL

EB75

B1250-HT (See page 8 for

installation

)

Removable Splash Guard and

Stopper Set - Instructions

Summary of content (2 pages)

PAGE 1
Removable Splash Guard and Stopper Set - Instructions A LOWER MOUNT RING STOPPER DISHWASHER INLET B REMOVABLE SPLASH GUARD MOUNT TAB DISPOSER C (Not Shown-Extended SInk Flange. 1” Longer) D FIBER GASKET E SUPPORT FLANGE F UPPER MOUNT RING G CUSHION RING NOTE: As the mounting assembly is properly assembled at the factory, please pay close attention to the order of the mounting system parts.
PAGE 2
(2. CONTINUED) INSTALLATION OF MOUNTING ASSEMBLY A. The Cushion Ring and the Lower Mount Ring will remain attached to the disposer during installation. Take apart the other parts of the mounting assembly by rotating the Lower Mount Ring clockwise until the Lower Mount Ring Tabs slide off from the Upper Mount Ring ramp (A1). This allows you to pull the Sink Flange up and out of the remaining Lower Mount Assembly. Note the order of these parts as they are arranged in the required order.