Bedienungsanleitung Eudora ProfiVap rapidone 715 Druckdampf-Bügelstation
EUDORA ProfiVap rapidone 715 BESCHREIBUNG 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) 13) 14) 15) 16) 17) 18) Dampfmengenregelung Ein/Aus-Schalter mit Leuchte für Bügeleisen Dampfkontrollleuchte Kontrollleuchte Wassertank leer Ein/Aus-Schalter mit Leuchte für Dampfstation Heizkesselverschluss Abstellfläche für Bügeleisen Verriegelung Wassertank Wassertank Tankverschluss Netzkabel Leuchte Bügeleisentemperatur Temperaturregler Bügeleisensohle Dampfstoßtaste Arretierung für Dauerdampf Korkgriff Anzeige/Programmie
BEDIENUNGSANLEITUNG: Sehr geehrte Kundin, sehr geehrter Kunde. Wir danken Ihnen für Ihr Vertrauen und gratulieren zum Kauf einer DruckdampfBügelstation von EUDORA. Vor Inbetriebnahme des Gerätes lesen Sie bitte diese Bedienungsanleitung genau durch und machen Sie sich mit dem Gerät vertraut. Für optimale Ergebnisse beim Einsatz und um Schäden zu vermeiden, befolgen Sie genau die Anweisungen. Die Bedienungsanleitung muss all jenen Personen, die mit dem Gerät arbeiten, zur Verfügung stehen.
• Arbeiten mit Dampf: - Den Dampfstrahl nicht auf Personen oder andere Lebewesen richten. - Niemals den Heizkesselverschluss unter Druck öffnen. (mind. 12 Stunden abkühlen lassen!). - Vorsicht beim sitzend Bügeln: Heißer Dampf dringt durch den Bügeltisch. Dampfaustritt und hohe Temperaturen können zu Verbrennungen führen! • Abstellfläche für Bügeleisen: - Das Bügeleisen sollte immer auf die vorgesehene Abstellfläche gestellt werden. - Die Dauerdampftaste beim Abstellen des Bügeleisens immer ausschalten.
Erste Inbetriebnahme Beim ersten Aufheizen kann eine leichte Rauchbildung auftreten. Dies ist vollkommen normal und verliert sich nach kurzer Benützung. Wir empfehlen daher, nicht als erstes empfindliches Bügelgut zu bügeln. Bügeln mit Dampf Zum Bügeln mit Dampf Temperaturregler (13) mindestens auf die Markierung ”Baumwolle Dampf” (siehe Symbol) einstellen. Dies gilt für alle Gewebearten. Nach jedem längeren Bügelunterbruch den Dampfstoß zuerst auf ein Tuch richten, bis er gleichmäßig ausströmt.
ANLEITUNG ZUR PROGRAMMIERUNG DER AUTOMATISCHEN ENTKALKUNGSANZEIGE Um die Entkalkungsanzeige festzulegen, müssen Sie den Härtegrad Ihres Wassers mit Hilfe des Wasserteststreifens, der dem Gerät beiliegt, bestimmen.
Unabhängig vom eingestellten Härtegrad, beginnen die LED-Anzeigen nach einiger Zeit des Betriebs eine nach der anderen – von (4) bis zu (1) – zu leuchten und zeigen damit den Wasserverbrauch des Geräts in Litern an. Wenn alle LED-Anzeigen nach dem Einschalten für eine Minute lang blinken und dann konstant leuchten, bedeutet dies, dass es notwendig ist, das Gerät zu entkalken.
BÜGELN MIT DAMPF 1. Der Wassertank (9) kann mit einer Flasche oder einem anderen verfügbaren Behälter direkt am Gerät, befüllt werden. Dazu ist es notwendig, den Tankverschluss (10) zu öffnen, den Tank zu befüllen und danach wieder zu schließen. Sie können den Wassertank aber auch entfernen, in dem Sie die Verriegelung (8) nach außen drücken und gleichzeitig den Tank heben, bis er komplett herausgezogen ist. Dazu gehen Sie wie folgt vor: 2.
Dieses Modell ist mit folgenden Funktionen ausgestattet: Rote Kontrollleuchte „Wassertank leer” (4) Ein rotes Warnlicht blinkt abwechselnd mit einem akustischen Signal, das anzeigt, dass der Wasser vorrat im Tank erschöpft ist. Die Folge ist ein kontinuierliches Brummen der Pumpe. Wir empfehlen, dass Sie nicht bügeln, wenn der Wasservorrat erschöpft ist, weil dies die Dampffunktion des Bügeleisens beeinträchtigen könnte.
mal mit normalem Leitungswasser. 6. Schrauben Sie den Heizkesselverschluss (6) mit dem Spezialschlüssel im Uhrzeigersinn wieder zu. Montieren Sie den Wassertank (9) wieder in seiner Position. ENTKALKEN 1. Versichern Sie sich, dass das Gerät abgekühlt ist und in den vorhergegangenen 12 Stunden nicht benützt wurde. 2. Versichern Sie sich, dass das Netzkabel (11) nicht an der Steckdose angesteckt ist. 3. Entfernen Sie den Wassertank (9). 4.
TECHNISCHE DATEN Totale Heizleistung: 2100 W Leistung Heizkessel: 1300 W Leistung Bügeleisen: 800 W Spannung: 230 Volt Dampfdruck: 4,0 bar / 400 kPa 11
Garantiebedingungen gültig ab 1.7.2006 Die EUDORA - Garantie wird für alle EUDORA Geräte geleistet, welche das Originalleistungsschild mit Gerätenummer aufweisen. Ohne die gesetzliche Gewährleistung einzuschränken, geben wir - abgesehen von den unter 2. Angeführten Fällen - 2 Jahre Garantie ab Kaufdatum (Nachweis ist der Kaufbeleg). 1.