User Manual

Source Four LED Mini User Manual 7
CAUTION: The canopy plate has built-in indentations
allowing the mounting plate bolts to nest into the canopy
plate. For an ideal flush-mount installation, you may need to
rotate the plate to accommodate these indentations. See the
following image.
1
1
2
2
Mounting plate
installation detail
Canopy
bolt hole
3
3
Canopy
bolt hole
Install the mounting plate screws in one of the three
position-pairings shown. Only the slots on the outer
circumference will allow a true flush mounting.
3. Place the copper ground braid loop over the ground bolt and
attach the ground bolt to the back box.
4. Connect the building ground wire to the ground wire on the
fixture, following local electrical codes.
5. Connect the supply power wires to the fixture wiring using the
included WAGO
®
connectors.
•
For 120 V fixtures: Connect the black wire to line and the white
wire to neutral.
•
For 230 V fixtures: Connect the brown wire to line and the blue
wire to neutral.
6. Use the canopy bolts to secure the fixture to the mounting plate.
7. Open all four shutter blades by sliding them outward until they
stop.
8. Install a gobo and gel as desired and confirm that they are properly
secured.
9. Restore power at the disconnect device.
10. Focus the fixture as needed.