Tip Kit Instructions

19511 Pauling, Foothill Ranch, CA 92610 USA | www.EssentialsForLiving.com
ASSEMBLY INSTRUCTIONS | EDEN 5 DRAWER HIGH CHEST
1. Attach one of the plastic brackets (04) securely near
the top back edge of the furniture piece by inserting the
screw (02). Refer to picture A.
2. Determine the final position of the furniture piece.
Mark location on the wall approximately 2” below the
plastic bracket (04) mounted to the back of the furniture.
3. Drill a starter hole into the wall stud. If a wall stud is
not available, drill a hole into the wall and insert nylon
wall plug (03). Gently tap plug until the flange of the plug
is flush with the wall.
4. Attach a second plastic bracket (04) by inserting and
securing the screw (02) to the wall. Refer to picture B.
5. Align the two plastic brackets (04).
6. Thread the plastic strap (01) through both plastic
brackets (04) and tighten until snug.
7. Check to make sure that the plastic brackets (04) are
firmly installed and the plastic strap (01) is secure.
8. Repeat steps 1-7 at other end of furniture piece.
Young children may be injured by tipping furniture and the use of a tipping
restraint is highly recommended.
When properly installed, this restraint could provide protection against the
unexpected tipping of furniture due to small tremors, bumps or climbing. We
recommend mounting this restraint to a wall stud.
WARNING: This product is only a deterrent. It is not a substitute for proper
adult supervision.
TIP KIT CHECKLIST
CODE
COMPONENT
QTY
01 Plastic Strap 2
02 Screw 8
03 Nylon Wall Plug 4
04 Plastic Bracket 4
FURNITURE TIPPING RESTRAINT
Installation Instructions:
WALL
Starter
holes
BACK SIDE
03
01
04
04
04
02
02
A B

Summary of content (1 pages)