User Manual

Operation
34
EverGuard Control Panel
Figure 5: ES7000EG System Configuration Menu
Note: The CPU A and CPU C are Read-Only parameters.
3. For Full and Part, Entry and Exit, roll to the desired parameter. The list of
time duration options appears. The range is 1 to 180 seconds. Note that
for compliance with the EN 50131 standard, both Entry and Exit times
must be set to values of 45 seconds maximum.
4. Click the desired parameter. The selection appears on the screen.
5. To enable Auto-Update of Date and Time, roll to the required checkbox and
click. The option is marked and synchronization of date and time between
the ES7000EG Control Panel and the Blackberry’s systems date and time
settings is enabled.
6. Roll to Duress Pin-Code: and enter the four-digit code to be designated
as the Duress Pin code on the control panel.
7. Click Video Config The Editing Video Scenario screen appears with a list of
the available scenarios.
Figure 6: Editing Video Scenario
8. Roll to the desired scenario and change what you want.
9. Click Update. You are prompted to save the changes.