User's Manual

ECH6 Transmitter (RTF Version) - Right hand throttle Mode1
10
EN
LCD Voltage Indicator: In the power-on state, the current transmitter battery voltage is displayed.
Beginner/Experienced Mode Switch: LO is Beginner Mode, HI is Experienced Mode.
Throttle Cut Switch: Red dot position is OFF, green dot position is ON.
Left Control Stick: UP and DOWN are Elevator Control, Left and Right are Rudder Control.
Right Control Stick: UP and DOWN are Throttle Control, Left and Right are Aileron Control.
Elevator Trim Lever: Fine tuning the Pitch Control
Rudder Trim Lever: Fine tuning the Rudder Control
Throttle Trim Lever: Fine tuning the Throttle Control
Aileron Trim Lever: Fine tuning the Aileron Control
Power Switch: Push up to power on, push down to power off.
Charging Indicator: ECH6 transmitter (RTF version) uses Alkaline Battery, so the transmitter charging
function is not available.
(Transmitter charging function is only available to LiPO batteries and NiMH batteries)
Reverse Switches: Control direction of movement of servos connected to the receiver.
AIL Reverse Switch: Control direction of movement for Channel 1, NOR is Normal, REV is Reverse.
ELE Reverse Switch: Control direction of movement for Channel 2, NOR is Normal, REV is Reverse.
THR Reverse Switch: Control direction of movement for Channel 3, NOR is Normal, REV is Reverse.
RUD Reverse Switch: Control direction of movement for Channel 4, NOR is Normal, REV is Reverse.
Caution: Using the THR mode prudently. Incorrect setting can cause right stick (throttle stick) operate
reversely (the aircraft motor will operate maximally when left stick push to bottom). Changing the throttle
control direction only affect the signal sent from the controller, and it will not affect the motor operate
direction.
Throttle Trim Lever
Aileron Trim Lever
Reverse Switches
Charging Indicator
Power Switch
Left Control Stick
Elevator Trim Lever
Rudder Trim Lever
Right Control Stick
SwitchThrottle Cut Switch
Beginner / Experienced Mode
LCD Voltage Indicator