User Manual\ 60cm\Slideout Rangehood\ SL63R
Contents\Page Welcome Section\04 General Safety\05 Product Overview\07 Installation\08 Instructions\13 FAQ\14 Other Useful Information\15 Purchase Details\17 Warranty\18
T 1300 11 4357 E info@residentiagroup.com.au W residentiagroup.com.au ACN 600 546 656 Dear Customer, Residentia Group PO Box 581 Stanhope Gardens NSW Australia 2768 Congratulations on purchasing your new rangehood. The Residentia brand is proudly distributed within Australia by Residentia Group Pty Ltd. Please refer to the warranty card at the rear of this manual for information regarding your product’s parts and labour warranty, or visit us online at www.residentiagroup.com.au.
General Safety Read this manual thoroughly before first use, even if you are familiar with this type of product. The safety precautions enclosed herein reduce the risk of fire, electric shock and injury when correctly adhered to. Keep the manual in a safe place for future reference, along with the completed warranty card and purchase receipt. If applicable, pass these instructions on to the next owner of the appliance.
General Safety Cont. Usage restriction: This rangehood is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children: Supervise young children to ensure they do not play with the appliance. Close supervision is necessary when any appliance is used by or near children.
Product Overview 1 2 3 4 7 5 7 6 Key to Product Overview 1 Rangehood housing 2 Slide-out Front Fascia Rail 3 Inner Aluminium Grease Filter 4 Outer Aluminium Grease Filter 5 On/Off Switch 6 Fan Speed Switch 7 Light 7
Installation Installation Kit The installation kit contains the following parts: Part ID Description 1 Rangehood 1 2 Rear-underside support mounting bracket 1 3 40mm Height Front Fascia Rail 1 4 Charcoal Filters —Already installed 1 set (2 pcs) 5 Screws (ST4 x 30mm) 6 6 Screws (ST4 x 8mm) 2 7 Wall Plugs (8mm) 6 8 Flat Washers 6 9 Front Vent Cover —If external ducting selected 1 10 Flu Outlet Adapter 1 8 Illustration Qty
Installation Cont. Unpacking • This product has been packaged to protect it against transportation damage. Unpack the appliance and remove all packaging materials from around the rangehood. Keep all packaging materials until you have made sure your new rangehood is undamaged and in good working order. The carton is recyclable. Whenever possible, reuse the carton and recycle it when disposing of the packaging materials.
Installation Cont. White Plastic Cover • When choosing the outdoor exhausting mode, you can cover the front outlet (part ID 9) with the white plastic cover. (fig. 5). Fig. 5 Recirculation Mode This mode is the default setting. The rangehood will operate with carbon filters and vent the air back into the kitchen. To ensure that the mode is correct, remove the grease filters (see Fig. 6) and check that the switch is in “Recirculation mode” position (Fig. 1). Fig.
Installation Cont. Removing and Installing Charcoal filters To remove the charcoal filters you will first need to remove the grease filters (see Fig. 6), now twist anticlockwise and pull down as shown in Fig. 8. Fig. 8 To install new charcoal filters you will need to first remove the grease filters (Fig. 9), now align the charcoal filters with the centre of the motors, twist clockwise (Fig. 9) and push upwards until they lock into place. Fig.
Installation Cont. • Drill 4 holes of Ø8mm on the wall, as illustrated below (Fig. 11). • Hammer the wall plugs into the holes, then insert two ST4x30mm screws into the lower wall plugs. Tighten the screws, but leave a 2mm gap so that you can hang the rangehood on the screws in the keyhole slots. • Hang the hood to the wall screws, and make sure the hood is in balance and positioned correctly. • Take away the Aluminum Filters, mark and drill another 2 holes of Ø8mm on the wall .
Installation Cont. • Install the rangehood onto the bottom of the cupboard and secure it in place with four ST4x30mm screws (Fig 13). • If there is a space between the wall and the rear of the rangehood, install the rear-underside support mounting bracket (Part ID 2, Installation kit) using the two ST4x8mm screws. WARNING: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards! Fig.
FAQs Troubleshooting guide If you experience problems with your rangehood, or it appears not to be operating correctly, check in the list below for answers to frequently asked questions. If none of the solutions offered help you solve your problem, please contact our after sales support line for advice. Do not attempt to repair the appliance yourself! Problem Possible Cause Solution The extractor fan ceases to function. There is no electrical current in the network.
Other Useful Information Cleaning and maintenance CAUTION! • Before cleaning the rangehood or carrying out maintenance, make sure the operation and light switches are set to the “ 0 ” position and the rangehood is disconnected from the power supply. • It is important to clean the filters regularly as oil and food residues can become a fire hazard. • Never use a steam cleaner to clean any part of the rangehood.
Other Useful Information Cont. Replacing a light bulb If the light bulb needs replacing, proceed as follows: • Slide out the front panel for easier access and remove the two aluminium mesh filters (Fig. 15). • Carefully turn the bulb in anticlockwise direction and remove (Fig. 16). • Replace the bulb with one of the same type and wattage (E14, 28W), as illustrated below (Fig. 17). Fig. 15 Fig. 16 Fig.
Receipt\ Purchase Details\ For your records, please record details of your purchase below and staple your receipt to the page. Store details Store name | Address | Telephone | Purchase date | Product details Model no. | Serial no.* | * Note. Your serial number can be found on the inside of the rangehood, underneath the grease filter.
Warranty\ Warranty terms and conditions Cooking appliances (rangehoods) This document sets out the terms and conditions of the product warranties for Residentia Group Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Appliance. 1.
\Warranty\Continued 5. You will bear the cost of transportation, travel and delivery of the Appliance to and from Residentia Group or its ASR.
Code\SL63R Model
