Installation Guide WALL MOUNT BATHROOM SINK
Installation Guide Tools and Materials Safety Glasses Measureing Tape Wrench Level Drill Pencil Silicone Caulk Included Hardware：(1)Hanger Bolts (10mm) x2 (2)Washer x2 (3)Nuts x2 (4)Anchor x2 (5)Insulation Sleeve x2 Before You Begin Read the following instructions carefully before you begin this installation: 1. Observe all local plumbing and building codes. 2. Shut off the hot and cold water supplies. Inspect the drain and supply tubing. Replace if necessary. 3.
Installation Guide Installation Steps Wall Mount Installation NOTE These fixings are suitable for solid walls only. Plasterboard or stud walls may require specialist fixings. Step I. Measure the distance between the center of each mounting hole on the back of the sink. Draw 2 marks on the wall in the desired mounting location. Ensure that the two marks are level with the floor. Step II. Drill two holes accordingly using a 14 mm masonry drill bit to a depth of 75 mm.
Installation Guide Step V. Apply silicone caulk around the edges of the sink where it meets the wall to prevent water from seeping behind the sink. Wait for 24 hours for it to dry. Step VI. Attach the P-trap assembly to the drain on the sink and connect it to the plumbing below. Install the water supply. Use a wrench to tighten the nuts and ensure there are no leaks. Congratulations! You have successfully installed a wall mount bathroom sink.
Installation Guide © COPYRIGHT 2023 ERIDANUS
