User Manual

Wireless SOHO

Installation and Operation Manual

2.4 Hardware Installation

2.4.1 Wall Mount of the LWS-BS or the LWS-WK

To wall mount the LWS-BS or LWS-WK, perform the following:

1. Remove the foot stand.

2. Make sure the handset retainer tab is positioned at ‘b’ as shown below figure.

Figure 2.4.1-1 Wall Mount of LWS-BS/ LWS-WK

3. Make a small mark on the wall where you want the top keyhole slot to align and install a screw (not

provided) so that it protrudes slightly, approx. 2.5mm, from the wall (Figure shown).

4. Measure a straight line down 10cm from the mark, and install another screw (not provided).

5. Align the keyholes on the back of the phone with the screws in the wall, and then slide the phone

down on the screws to secure the phone.

¾ Ensure all cables are properly routed and if necessary, that power should be installed before

affixing to the wall mount screws.

Note:

Wireless SOHO

Installation and Operation Manual

2.5 Component Description

2.5.1 LWS-BS Description

1. Handset 2. Navigation/OK Key

3. Speaker 4. Menu Button

5. DND Button 6. Headset Button

7. Volume Up Button 8. Volume Down Button

9. Antenna 10. Ring Indication Light

11. LCD 12. Line/Station Selection Buttons

13. Soft Buttons 14. MSG (Message) Button

15. Dial Buttons 16. Transfer Button

17. Hold Button 18. Mute Button

19. Speaker Button 20. Microphone

Figure 2.5.1-1 LWS-BS Component Description