Operation Guide
Table Of Contents
- Copyright Information
- Disclaimer
- Contents
- Diagram Index
- Table Index
- Notice
- User Service
- 1 Introduction
- 2 Interface and Component
- 3 Functions and Operation Instruction
- 3.1 Startup & Shutdown Button
- 3.2 Left and Right Buttons
- 3.3 Up and Down Buttons
- 3.4 Data Transmitting-receiving Indicator Light
- 3.5 3G/4G and Bluetooth Operating Condition
- 3.6 Instruction of Radio Startup and Power Indicator Light Conditions
- 3.7 Device Menu
- 3.7.1 Device Information
- 3.7.1 Device Information
- 3.7.2 Transmitting/Receiving Channel and Frequency
- 3.7.3 Data Protocol
- 3.7.4 RF Baud Rate
- 3.7.5 Transmitting/Receiving Mode
- 3.7.6 Transmitting Power
- 3.7.7 Serial Port Baud Rate
- 3.7.8 Serial Port Baud Rate Self-adaption
- 3.7.9 OLED Sleep Mode
- 3.7.10 Interference Detection
- 3.7.11 Language
- 3.7.11 Language
- 3.8 Use of Radio Configuration Software
- 3.9 Firmware Upgrade
- Appendix A Technical Indexes
- Appendix B Command
- Appendix C eRadio SIM Setup
- Appendix C eRadio SIM Setup
- Appendix D eRadio FAQ
3.7.11 Language
Set up the display language of device fonts, Chinese and English are
supported for this terminal.
3.8 Use of Radio Configuration Software
Multiple forms of configuring radio parameters are supported. Users can
change and query the current radio parameters by the means of background
mode, user interface mode and PC configuration tool. The use methods of the
PC configuration tool are introduced as below.
The procedures of radio parameters include:
Communication link establishment
Configuration tool installation
Radio parameter query
Radio parameter configuration
3.8.1 Configuration Environment
Firstly, build up the radio parameter configuration environment, devices
needed include: Power supply (12V), power cable (integration of power cable
and data cable), radio, PC. And then, assemble related components according
to Figure 3