User's Manual

Getting to Know Your Printer 11

R4C3730

Rev. B

A5 size INTRO.FM

5/10/99 Pass 0

Proof Sign-off:

<Crestec> _______

<Kimura> _______

<Crestec> _______

❏ If you use an extension cord with the printer, make sure the

total ampere rating of all devices plugged into the extension

cord does not exceed the cord’s ampere rating. Also, make

sure the total of all devices plugged into the wall outlet does

not exceed the wall outlet’s ampere rating.

❏ Unplug the printer before cleaning, and clean it with a damp

cloth only.

❏ Do not spill liquid on the printer.

❏ Except as specifically explained in this guide, do not attempt

to service the printer yourself.

❏ Unplug the printer and refer servicing to qualified service

personnel under the following conditions:

If the power cord or plug is damaged; if liquid has entered

the printer; if the printer has been dropped or the cabinet

damaged; or if the printer does not operate normally or

exhibits a distinct change in performance. Adjust only those

controls that are covered by the operating instructions.

❏ Printer parts marked with this symbol may be hot.

Turn off the printer and let it cool for a few minutes

before you touch any printer part marked with this

symbol.

❏ If you plan to use the printer in Germany, observe the

following:

To provide adequate short-circuit protection and over-

current protection for this printer, the building installation

must be protected by a 16 Amp circuit breaker.

Note for German-speaking users:

Bei Anschluß des Druckers an die Stromversorgung muß

sichergestellt werden, daß die Gebäudeinstallation mit einem 16

A-Überstromschalter abgesichert ist.