Operation Manual

❏ TCP/IP

❏ Auto

Select when you are using a wireless router at home or you are allowing the IP address to be acquired

automatically by DHCP.

❏ Manual

Select when you do not want the printer's IP address to be changed. Enter the addresses for IP Address,

Subnet Mask, and Default Gateway, and make DNS Server settings according to your network environment.

When you select Auto for the IP address assignment settings, you can select the DNS server settings from

Manual or Auto. If you cannot obtain the DNS server address automatically, select Manual, and then enter the

primary DNS server and secondary DNS server address directly.

❏ Proxy Server

❏ Do Not Use

Select when you are using the printer in a home network environment.

❏ Use

Select when you are using a proxy server in your network environment and you want to set it to the printer.

Enter the proxy server address and port number.

❏ IPv6 Address

❏ Enable

Select this when using an IPv6 address.

❏ Disable

Select this when using an IPv4 address.

❏ Link Speed & Duplex

Select an appropriate Ethernet speed and duplex setting. If you select a setting other than Auto, make sure the

setting corresponds to the settings on the hub you are using.

❏ Auto

❏ 10BASE-T Half Duplex

❏ 10BASE-T Full Duplex

❏ 100BASE-TX Half Duplex

❏ 100BASE-TX Full Duplex

Checking the Network Connection Status

You can check the network connection status in the following way.

User's Guide

Network Settings