Owner's Manual

- PRINTHEAD MAINTENANCE KIT -
R
Head cleaning is complete when the
p
light stops flashing and
remains lit.
If clogged nozzles are still detected after performing a [Head Cleaning], execute
[CR Unit Adjustment/Maintenance] - [Head Cleaning] - [Nozzle Check] from the
Maintenance Utility again.
If clogging is detected after performing [Detect Clogging], perform [Powerful]
cleaning for the head that is clogged.
N
“SL-D3000 Administrator’s Guide”
This completes cleaning.
Troubleshooting
i
i
If printouts are still dirty after cleaning using this kit (if it is the same as before
cleaning or if new dirt appears).
Contact the repair center.
i
i
If error ID 7301 is displayed.
See the "Troubleshooting" section in the "SL-D3000 Operation Guide".
BEMCOT is a trademark of Asahi Kasei Fibers Corporation.
14