Owner's Manual

68 Saving and Storing Photos
1. Remove any memory cards from the RX700.
2. Connect your USB drive to the RX700 as shown on page 66.
3. When you see this screen, use the u and d buttons select which folder to
print from, then press
OK.
4. Press the
Memory Card button, then follow the same steps as you would to
print from your camera’s memory card (see page 27).
Removing a Memory Card
Once you’re finished copying photos from your memory card to your computer,
follow the steps below to prepare your computer before removing the card. Be sure
to remove any cards before unplugging the USB cable from your RX700.
Caution:
Do not eject a card while the memory card light is flashing, or without performing the
steps described below, or you may lose data on the card. Be sure all cards have been
removed before unplugging the USB cable.
1. On a Macintosh, drag the memory card icon from your desktop to the trash.
If you’re using Windows XP or 2000, click the
Unplug or Eject
Hardware
icon on the taskbar. In Windows XP, click Safely Remove USB
Mass Storage Device
. In Windows 2000, click Stop USB Mass Storage
Device
.
Note:
In Windows 98 or Me, you don’t need to do anything on your computer before
removing a card.
2. Remove the card by pulling it straight out of the slot.