User's Manual

If you removed one hard disk drive and are leaving another

one in the computer, you need to set the jumpers on the

remaining drive to indicate that you now have only one hard

disk drive. For the correct settings, see the documentation that

came with the drive.

Installing a Drive in a Horizontal Bay

This section describes how to install a drive in a horizontal

drive bay. Although the illustrations show a diskette or hard

disk drive in the lower bay, you can use these same instructions

to install a diskette drive in the upper bay.

Here you’ll find steps for the following procedures:

Attaching the mounting frames to a hard disk (if necessary)

Installing the drive

connecting the cables.

If you are installing your computer’s first hard disk drive,

it is best to install it in the vertical drive bay as described on

page 3-5.

Note

Before you install a hard disk drive, be sure to check the

jumpers on the drive. For instructions, see page 3-4.

Installing and Removing Drives

3-17