User's Manual

Accessing Your System
If you have forgotten your current password, follow these steps
to access your system:
1.
2.
Turn off the computer.
Follow the instructions under “Changing the Jumper
Settings” in Chapter 2 to disable the password function by
setting jumper J13 to position A.
3.
4.
Turn on the computer.
When you see Press <F2> to run SETUP, press [nl.
You see the SETUP screen. If you do not want to set a new
password, go to step 6. If you want to set a new password,
go to step 5.
5. To set a new password, highlight Password and press [Mwl
Then press F2
25
Type a new password at the prompt and
press [bcrl You must enter the new password twice. (See
Chapter 2 of the Setup Guide for more information about
setting a password.) Now go to step 7.
6. To disable password checking, highlight Password
security and press m Then press (Zl or [-1 to
change the setting to not installed. (See Chapter 2 of
the Setup Guide for more information.)
7.
Save your settings as you exit SETUP. (See Chapter 2 of the
Setup Guide for instructions.)
8.
Turn off the computer.
9. Follow the instructions under “Changing the Jumper
Settings” in Chapter 2 to enable the password function by
setting jumper J13 to position B.
6-10 Troubleshooting