Administrator's Guide

Setting Up the Projector

When projecting from a table, the ideal arrangement is to set the

projector flat on its surface. This way, you can use the lens shift knob

(instead of raising the projector’s feet) to position the image on-screen.

This delivers the best-looking picture. (See chapter 2 for details.)

You won’t need to tilt the projector upward as long as you position it

so that its lens is at least as high as the bottom of the screen, but no

higher than the middle of the screen, as shown:

If you have to raise the front of the projector, you can use the

projector’s keystone correction to eliminate distortion caused by

tilting the projector upward. But you’ll get a better picture if you can

leave the projector flat on the table and use the lens shift knob to

adjust the height of the image.

If you’re projecting from overhead, you can get the best-looking

picture by mounting the projector parallel to the ceiling, with its lens

at least as high as the middle of the screen, but no higher than the top

of the screen. Then use the lens shift knob to position the image

on-screen.

no lower than

bottom of screen

no higher than

middle of screen

ideal

range

note

After positioning the

projector, you may want to

connect a Kensington

MicroSaver

anti-theft

device to the lock port on the

projector’s left side. You can

purchase this from EPSON;

see page 13