Owner's Manual

Note :
If the screen fonts have already been installed, the following message
appears in step 9. Click Quit to leave the installer if this occurs.
Installation on “HD-SCSI 0” was
successful. If you are finished, click Quit
to leave the Installer. If you wish to do
additional installations, click Continue.
To enable the printer drivers, follow the instructions in the next
chapter, “Setting Up Your Macintosh.”
Customize installation
Note:
You can copy only the files you need from the disks using this
installation method. If you cannot print correctly after this installation,
perform the Easy Installation to copy the necessary files and modify
your system settings.
Steps 1 to 6 are the same as the steps in the Easy Installation.
Follow the steps in that section first. From step 7, follow the
procedures below:
7. Click Customize to open the Customize Installation window.
The Customize Installation window is displayed.
Installing the Programs
1-5