Owner's Manual

Cut-Sheet Feeder

CAUTION: Do not use envelopes multi-part forms,

carbon paper, or labels in the single-bin cut-sheet feeder.

Insert up to 50 sheets of paper along the left paper guide.

Adjust the position of the right paper guide so that it matches

your paper’s width. Make sure the position of the guide allows

the paper to move up and down freely.

Push the paper-set levers back to clamp the paper against the

guide rollers.

Attach the stacker-support wires to the edge guides of the

paper guide. Then place the notches on the paper guide straight

down over the mounting posts on the printer to reinstall it.

Slide the edge guides to the middle of your paper.

You can still insert single sheets using the rear paper guide or the

front paper slot. The cut-sheet feeder automatically loads paper

when you send print data to the printer (as long as the PAUSE light

is not lit). You can also load paper from the cut-sheet feeder by

pressing the

LOAD/EJECT

button.

Using the Printer Options

4-5