Owner's Manual

Using Continuous Paper

The printer allows you to easily switch between the cut sheet feeder

and the tractor feeding system without having to remove either the

feeder or the continuous paper supply.

Make sure the continuous paper is already loaded and in the

standby position as explained in Chapter 2.

Install the cut sheet feeder as described in this section, making

sure that DIP switch l-7 is set to on.

If a single sheet is still in

the

printer, eject it by pressing the

LOAD/EJECT

button.

To switch from the cut sheet feeder to continuous paper, pull the

paper release lever forward to the push tractor mode position

(the middle position). You do not need to change the setting of

DIP switch l-7.

CAUTION:

When using the built-in push tractor only, be

sure that the paper release lever is always in the push

tractor position.

5-16

Using the Printer Options