Owner's Manual

Tear Off

When you resume printing, the printer automatically feeds the

paper back to the loading position and begins printing. (You can

also manually feed the paper back to the loading position by

pressing the

TEAR OFF

button again.)

Adjusting the tear-off position

If the paper’s perforation does not meet the tear-off edge, follow the

steps below to adjust the tear-off position:

Make sure the paper is in the tear-off position and the

READY

light is blinking.

While holding down the

ALT

button, press the

PAUSE

button to

enter the micro-feed feature. The

FONT

and

CONDENSED

lights

blink alternately.

Press the

PAUSE/TEAR OFF

button to move the tear-off position

down on the page, or press the

PAPER FEED

button to move the

tear-off position up on the page. The printer remembers the new

tear-off position even after you turn off the printer.

Tear off any printed pages.

When you begin printing, the printer automatically feeds the

paper back to the loading position and begins printing.

Note:

The printer has a minimum and maximum tear-off position. If

you try to advance the loading position beyond the limits, the

printer beeps and the paper stops moving.

When the paper reaches the factory-set tear-off position, the

printer beeps and paper feeding pauses briefly. Use the

factory setting as a reference point when you adjust the tear-

off position.

3-20

Using the Printer