User's Guide

66
Problems Using the Remote Control
Problem Solution
The system doesn’t respond to
the remote control.
Make sure you’re within about 20 feet of the screen. Point the remote control
toward the sensor at the top of the screen.
You may need to replace the remote control’s batteries (see page 59). If you
suspect they are weak, press the
LIGHT button on the side of the remote control
and verify its screen and buttons light up. (You need to be in a darkened room to
see this.) If they don’t light up, replace the batteries.
Turn off any fluorescent lights. Make sure the screen is not in direct sunlight.
Turn off nearby equipment that emits infrared energy, such as a radiant room
heater.
If you changed any of the remote control’s RF settings (see page 81), make sure you
didn’t disable the remote control’s IR LED.
The
ON and OFF buttons don’t
operate the system.
Press the MAIN button first, then press either ON or OFF. Keep the remote control
pointed at the screen for several seconds after you press the button to ensure that
all the components in the system turn on or off.
When the numeric keypad is
used, there is a delay before your
selection is transmitted.
After entering digits with the keypad, press the
SEL (Select) button to transmit your
selection right away. If you don’t press
SEL, the selection will be transmitted after a
brief delay.
The
ENT (Enter) button doesn’t
work with the numeric keypad.
The ENT (Enter) button is meant for use with other components that may require it,
such as cable box. Use the
SEL (Select) button with the numeric keypad when
operating the Ensemble HD system.
You want to return to the main
menu of the DVD you’re
watching to select its contents.
Press the
MENU or GUIDE button to display the main menu of a DVD.
(The
MENU button displays the Ensemble HD setup menu if the MAIN menu is
displayed on the remote control. If a different menu is displayed, such as
CABLE or
SAT, it displays the menu system for that component.)
You want to view information
about the selected audio or
video source.
Press the
OSD (On-Screen Display) button on the remote control.
You want to view chapter
information for the DVD you’re
watching, or check the amount
of time remaining.
Press the
INFO button on the remote control.
You tried using advanced remote
control setup features, and now
the remote control doesn’t work
correctly.
You can restore the remote control’s original settings. See “Restoring Remote Control
Factory Defaults” on page 83.
The remote control has been lost
or damaged.
Contact Epson for help (see page 69).