User's Manual

The table below describes the parameters you can use to
modify the way the program runs on your computer.
Note
To run the System Configuration program in non-target
modeling mode, add the /N parameter to the command line.
Modeling mode only affects the way the configuration
program operates; it does not affect any of the other utilities
you can run using the SD command.
SD command parameters
Parameter Mode
/B
BIOS video mode
/H
t
IK
/M
High resolution
display mode
Keyboard only
mode
Monochrome
display mode
Non-target
modeling mode
f
c
c
Function
-
Causes the program to be displayed
using BIOS Int 10h calls for systems using
non-standard displays. In default mode,
the program writes directly to the video
memory
Displays 43 lines per screen on an EGA
monitor and 50 lines per screen on a
VGA monitor. In default mode, the
screen displays 25 lines.
Sets the program so a mouse cannot
be used, even if you have installed one.
In default mode, you can use a mouse
as long as a mouse driver is loaded.
Causes the program to be displayed in
black and white only. In default mode,
color monitors will display in color.
Allows you to run the System
Configuration program in non-target
modeling mode.
Using the CF Command
If you want to run the System Configuration program from
your hard disk, first follow the instructions under “Copying the
Configuration Files to a Hard Disk” below.
2-22 Running System Configuration