Owner's Manual

Using SelecType
4.
Press the SET button again to set the emulation.
5.
Press the SET button a third time to enter the emulation
submenu, where you can change these options:
FONT SOURCE
ORIENTATION
FONT NUMBER
CONDENSED
FORM
ZERO
SYMBOL
INTL CG
SKIP-OVER
AUTO LF
CG TABLE
TOP OF FORM
6.
Use the or button to select a function to change.
Note: This submenu does not work in a loop. Pressing the
button when the first item is displayed or the button when
the last item is displayed causes you to exit the emulation
submenu and return to the main menu.
7.
Press the SET button to activate the option. The function stops
blinking, and the option starts blinking.
8.
Use the or button to move to the option you want to set.
9.
Press the SET button. An asterisk (*) appears next to the option,
indicating that the new option has been set. The option stops
blinking; the function starts blinking.
10. To exit the emulation submenu and return to the main menu,
use the or button to take you back to the main menu. The
message EMULATION = HPLJ2* or FX* appears.
If you wish to exit SelecType at this point, see the section on
exiting SelecType later in this chapter.
Using the Printer
3-15