INSTALLATION MANUAL ELPMB50 Frame for Epson projectors Epson Epson Epson Epson Epson Epson 1 5 6 7 7 8 9 Only a qualified technician should install this product. Read these instructions carefully before installing the ELPMB50 projector frame. Please also read the product manual of the specific projector carefully. These instructions must always be handed over to the installing person.
SAFETY INSTRUCTIONS Dear customer, for your safety, read all the instructions in this installation manual before using this product. Incorrect handling that ignores instructions in this installation manual could damage this product or could result in personal injury or property damage. Keep this installation manual at hand for future reference. ELPMB50 Model number: This frame is DGUV V17 (BGV-C1) certified. Please consider the valid laws at the place of event.
SAFETY INSTRUCTIONS SAFETY PRECAUTIONS FOR INSTALLATION Warning Follow the instructions in this guide when installing this product. If the instructions are not follow, this product may fall, resulting in personal injury or an accident. Do not install this product in an unstable location. Make sure the installation location is strong enough to support the weight of the projector and this product. Do not use adhesives, lubricant, oil, and so on when securing the screws.
SAFETY INSTRUCTIONS SAFETY PRECAUTIONS FOR INSTALLATION Caution Do not install this product in a location subject to temperatures outside the projector’s operating range. The may cause malfunctions to occur. Do not install the projector in a location where it may be subject to vibrations or shocks. When securing the frame with bolts, make sure you do not catch your hand or finger between the bolts and the frame. Do not stack more than three projectors in a stacked configuration.
SAFETY INSTRUCTIONS NOTES ON USAGE Warning Modifying and disassembling should only be performed by qualified service personnel except when explicitly stated. Otherwise, malfunctions or accidents may occur. Do not hang from this product. Also do not hang any objects on this product except for the projector If this product breaks and falls, it could cause death or personalinjury. Do not stand or sit on this product. Otherwise, the product could be damaged.
PRODUCT DESCRIPTION Parts name Image / Drawing Purpose Frame Used for projector installation. Screws and washers Used for securing the projector into the frame. Screws (M6 x 20) x 4 Flat washers (M6) x 8 max. 2mm 5. Finished assembly diagram For tandem assemblies, another separate frame is required.
INSTALLING THE PROJECTOR IN THE FRAME Place the frame on the projector so that it is aligned with the screw hole positions. (Make sure that the forward/back direction is correct when installing. If the direction is reversed the hole positions will not match.) Please make sure to use ONLY the correspondent screw holes when installing a projector! screw (M6x20) Secure the projector in the frame using the four screws (M6x20) and the eight flat washers (M6).
STACKING PROJECTIONS female bolt male bolt locking pin Place the upper framed projector on top of the lower frame projector. Make sure the four male location bolts enter into the correspondent female location bolts. To secure, draw the locking pin through both bolts. MAXIMUM STACKING INFORMATION Epson EB-L-Series ceiling mount with TH-SHORT-60-6 ceiling mount with TH-SHORTY-150-8 table mount 7.
ADJUSTMENT OPTIONS TILT ADJUSTMENT By lifting the front left or the front right corner an adjustment of 3.5 degrees upwards and downwards is possible. adjusting screws HORIZONTAL ADJUSTMENT By turning the single round adjustment screw, placed on the side of the frame, you can move the back of the projector to the left or to the right by approximately 5 degrees.
DIMENSIONS & WEIGHT Weight: 12,50kg 179mm 7,047in 733,75mm 28,888in 339,6mm 13,370in 235mm 9,252in 642mm 25,276in 706mm 27,795in 9.
Made in Germany for by Sager Metallbearbeitung www.lang-ag.
