Installation Guide

ELPMBUNI

Installation Manual Page - 9 -

Securing the Bracket to the Projector

NOTE: The two-piece mounting legs are designed to allow routing of the legs around critical ventilation

screens on the base of the projector as shown. You may also reduce the two-piece leg to a one-piece

leg as shown for a better overall fit to the projector.

1. Locate the mounting points on the bottom of the projector and use the appropriate number of mounting

legs.

2. Select the mounting hardware that your projector requires and loosely install the universal mount to your

projector.

NOTE: If your projector requires M3 mounting hardware. Use the M3 x 16 Phillips screws with the M3

flat washers (supplied). Insert the M3 x 16 Phillips screws with the flat washers attached through

the leveling barrel. Using a Phillips screwdriver, loosely secure the screws to the projector

(Figure A).

NOTE: The levelers and leg assembly screws must be loose in order to adjust the height of the mounting

bracket.

Figure 5

FIGURE A

FIGURE

One-Piece

Leg

FIGURE

Two-Piece

Leg

Leveling

Barrels

Mounting

Hardware

Allen

Wrench

Inverted

Projector

Line u

the levelin

barrels to the mountin

oints.