User`s manual

- 62 -
SuperIO Device
Option are in its sub-menu.
Press<Enter>to enter the sub-menu of detailed options.
Onboard FDC Controller
This item specifices onboard floppy disk drive controller. This setting
allows you to connect your floppy disk drives to the onboard floppy
connector.
Ø The choice: Enabled or Disabled.
Onboard Serial Port1
This option is used to assign the I/O address and interrupt request ( IRQ
) for the onboard serial port1 ( COM1 ).
Ø The choice: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
or Auto.
Onboard Infrared Port
This option is used to assign the I/O address and interrupt request ( IRQ
) for the onboard infrared port.
Ø The choice: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
or Auto.
UART Mode Select
This field is available if the Onboard Serial Port 2 field is set to any option
but disabled. UART Mode Select enables you to select the infrared com-
munication protocol-Normal ( default ), IrDA, or ASKIR. IrDA is an infra-
red communication protocol with a maximum baud rate up to 115.2K
bps. ASKIR is Sharp's infrared communication protocol with a maximum
baud rate up to 57.6K bps.
Ø The choice: SCR, IrDA or ASKIR .
UR2 Duplex Mode
This item is available when UART 2 mode is set to either ASKIR or
IrDA. This item enables you to determin the infrared function of the
onboard infrared chip. The options are Full and Half ( default ).
Full-duplex means that you can transmit and send information simulta-
neously. Half-duplex is the transmission of data in both directions, but
only one direction at a time.
Ø The choice: Full or Half.