User's Manual

CDMA FWT SXT-2180 9 Technical Manual
ⅤI. Setting Menu
New Code ‘##41’
- You can change a lock code which is being ‘0000’ as default value.
- After enter a command of ‘##41’, you can heard a lock code sound immediately.
- At this time, You should enter the current lock code to get an authority to change a lock code.
- If the entered current lock code is right, a confirmation tone will be heard.
- After then, You can try to enter new lock code. The processes of an entering new lock code have two steps. First,
you should enter a new lock code and press ‘À’ key. And then, you should enter the lock code again to make a double
check and press ‘À’.
- If first code and second code was matched, a confirm tone will be heard. Otherwise, the codes are different. You
should do all process again from beginning.
- Press ‘#’ to cancel
Ex) Suppose that the current lock code is ‘7777’, and user wants to change it to ‘8888’.
##41 Î a lock-code prompt sound Î 7777 Î a confirmation tone Î 8888 Î Press À Î 8888 Î Press À Î a
confirmation tone
Restrict outgoing ‘##42’
- You can restrict outgoing call.
- You can set a restriction by pressingÀ.
- Press ‘#’ to cancel what you did.
Reset phone ‘##43’
- You can reset this terminal to make a default factory value.
- You can reset a terminal by pressing ‘À’ and a FWT will be reset.
- Press ‘#’ to cancel what you did.
Voice privacy ‘##44’
- You can set the option of Voice privacy to protect your voice from tapping But It is possible only an operator supports
this feature..
- You can change the option by doing follows.
- Press ‘À’ for changing a current value to ‘Standard’ option
- Press ‘#’ for changing a current value to ‘Enhanced’ option.
NOTE: If you want to change a option of the voice privacy on your conversation, you may press
“À À 0À ” for standard mode or “À À 1À ” for enhanced mode.
Ex) Suppose a current lock code ‘7777’
##44 Î a lock-code prompt sound Î 7777 Î a confirmation tone Î Press ‘#’ : Enhanced
##44 Î a lock-code prompt sound Î 7777 Î a confirmation tone Î Press À : Standard
Auto Gain Control ‘##45’
- You can set AGC which is able to adjust volume level according to the order from BTS..
- After entering a command of ##45,
- Press ‘À’ to make it enable
- Or press ‘#’ to make it disable