User's Manual

EZBee series Manual / Ver. 1.0
7
customers for more flexible and effective communication.
A specified own ID and an extended/ short address are assigned for
each modem of EZBee formats. The specified own ID is used for pointing
a data receiving modem in every data transmission modes.
The specifications of EZBee
TM
is summarized as follows:
EZBee Specifications
Communication range 2500m (LOS)
TX power 0 dBm ~ 18 dBm (selectable by software)
RF Data Rate 250,000 bps
Serial Interface Data Rate 1,200 – 115,200 bps (selectable by software)
Receive sensitivity -100dBm (packet error ratio 1%)
Supported Network Topologies Point-to-point, point-to-multipoint, peer-to-peer
Number of Channels
16 direct sequence channels (selectable by
software)
Addressing Options PAN ID, Channel, Addresses
EZB
EZBEZB
EZB-
--
-S100,
S100, S100,
S100, EZB
EZBEZB
EZB-
--
-U100
U100U100
U100 and
andand
and EZB
EZBEZB
EZB-
--
-L100
L100L100
L100 comply
complycomply
comply with part 15 of the FCC Rules. Operation is
with part 15 of the FCC Rules. Operation is with part 15 of the FCC Rules. Operation is
with part 15 of the FCC Rules. Operation is
subject to
subject tosubject to
subject to the following two conditions:
the following two conditions: the following two conditions:
the following two conditions:
(1) This device may not cause harmful interference, and
(1) This device may not cause harmful interference, and (1) This device may not cause harmful interference, and
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
(2) this device must accept any interference received, including(2) this device must accept any interference received, including
(2) this device must accept any interference received, including interference that may
interference that may interference that may
interference that may
cause undesired operation.
cause undesired operation.cause undesired operation.
cause undesired operation.